Preparation
1.Ensure that the datalogger is reliably connected to the ports on the device.
2.The power indicator of the datalogger is on.
1. Login and register
1.1 Sign up
Open the APP and click the "Sign up" button to enter the registration interface.
After entering your mobile phone or email, click "Send"
After entering the verification code and login password, click "Rign up now" to complete the account registration.
Password login
Enter the e-mail address password you just used to register including the password, and click "Login" .
Verification code login
Click
Or
Icon, start the verification code login;
Enter the mobile phone or email you used when registering and click "Send"
After entering the verification code, you can log in to the system
2. Add Device
There are two methods for adding devices:Bluetooth addition and Scan addition
After logging in, on the monitoring page, click Add Device to enter the Add Device page.
Or click the "+" button in the upper right corner to add a device
Allow the App to enable Bluetooth and location permissions when using the Bluetooth addition feature.
Make sure that after the device is powered on, select the same device as the PN, click the "+" icon, and click "OK" to add the device.
Click "Scan addition" to scan the two-dimensional code of the number sampler or click "Enter PN" in the lower left corner to enter the number sampler PN to complete the addition of equipment.
Note:
If it is a digital sampler with Wi-Fi module, you need to configure the network before you can see the equipment monitoring data.
After the equipment is successfully added, the data acquisition device containing the Wi-Fi BLE module will automatically enter the "networking configuration" interface.
Step1：
Click"
"Icon, select the router to be configured, enter the corresponding password, and click the" Start Networking "button;
Note:
1. Please ensure that the signal connected to the network is good and the network is smooth.
2. Currently, routers in 5G band are not supported, please use routers in 2.4G Band.
3. Make sure the router password is correct
Step2：
After entering the configuration, wait for 10s,APP will feedback information according to the distribution network result.
If the distribution network is successful, click "confrim" to return to the device list and wait for about 1 minute to view the device data normally;
If the configuration fails, view the "diagnosis results and repair suggestions", and click "reallocate network" after troubleshooting .
Click the links below to check more information
----------------------------------------------------------------------
-------------------------------
-------------------------------
----------------------------------------------------------------------